The Mesa V2 seat pad, infant insert, buckle pad, and shoulder pads can be machine washed on the gentle cycle. Lay flat to dry. We recommend spot cleaning the canopy and plastic parts. The harness webbing should be cleaned with warm water and dish soap.

Click here for further cleaning information or reference your user manual. 

Check out these how-to videos for fabric and canopy removal and attachment.

Yes, the Mesa V2 carrier is FAA approved when used according to the instruction manual We suggest you travel with your Mesa V2 in flight for optimal safety. The Mesa base is not approved for aircraft use.

Click here to learn about our TravelSafe program.

Click here for the Mesa Travel Bag.

Use our professional installation instructions to learn how to install the Mesa V2 car seat without the base. Find out the right procedures for a safe and secure installation.

Install Mesa V2 without base by following our professional guide. For easy and flexible use, learn how to install the car seat safely.

The base is not required to achieve a safe and secure install. The lap belt routes through the guides on the carrier that are located near the carry handle, and the shoulder belt routes behind the carrier through the guide located above the carrier release from base handle. Reference the Mesa V2 manual and vehicle manual for seat belt installation guidance.

Click here to learn how to install the Mesa V2 using European belt routing.

Ensure the red line on the side of the carrier is parallel to the vehicle floor rather than the ground outside the vehicle. Ensure the back angle of the carrier stays in the correct position and the carry handle is placed in the 4^th position.

You do not need a mat with the Mesa, as the base has a finished bottom that prevents damage to seats. If you do choose to use a mat, the only non-regulated mats approved and tested for use with the Mesa include: Brica, Munchkin Auto Seat Protector, Diono Super Mat and Diono Ultra Mat.

State and federal safety standards require all car seats meet stringent flame retardancy standards (also referred to as FMVSS 302). For the Mesa V2, UPPAbaby meets this standard without applying any fire-retardant chemicals to the fabric that is in direct contact with the child. The foam that is underneath the fabric is treated to meet this requirement, however, the composition does not include harmful chemicals. Additionally, the Mesa V2 is GREENGUARD Gold Certified which tests for low chemical emissions, VOC’s.

This Mesa V2 Infant Insert is designed to optimize fit and body positioning for your child. The following fit criteria must be achieved before the insert can be removed.

1. Harness straps are at or slightly below shoulders.
2. Bottom of the headrest is positioned at or up to 1 inch above shoulders.
3. Chest clip is at armpit level.
4. Crotch buckle rests securely against child with no gaps and child is not sitting on top of the buckle.
5. Room to tighten harness properly.
6. Child is not slouching.

* NOTE: You may continue to use the Infant Insert beyond 11lbs until all criteria are met.

Click here for an instructional video or schedule a virtual car seat fit appointment.